Using the burner
　　 A. Place the burner correctly on the burner.
　　B. Lightly press/open the burner with the left hand, and squeeze the suction pen with the right hand to suck the IC.
　　Note: When pressing the burner, the force on both sides should be even, and the pressure should be applied in the vertical or horizontal socket direction, and it should not be pressed at an oblique angle, otherwise the burner will be easily damaged.
C. Suck the IC well, put the IC horizontally in the burning socket, when the IC is 1~2mm above the needle in the burning socket, squeeze the suction pen to release the IC, let it fall into the burning socket freely, do not directly Press the IC into the programming socket, and then forcefully remove the suction pen. If you feel that the IC has not been stabilized, use a suction pen to gently dial the IC or suck it up again.
　　D. After the IC is placed correctly, let go gently and let the pressure shafts on both sides of the burner stand press firmly on the IC.
　　Note: When letting go, make the pressure force on the IC evenly, and let go gently, otherwise it is easy to make the IC press unstable, and the programming needle is broken.
　　Precautions for use
　　◆For different IC packaging parameters, you must use a matching IC burner
　　◆If the IC cannot be inserted, please do not force it
　　◆Check the burner before use:
1. The metal shrapnel in contact with the IC is gold-plated, and the color is golden yellow. If it is found to be black or uneven in color, it can be judged that the metal shrapnel has been oxidized, and it should be stopped immediately. br> 　　 2. If the metal shrapnel is broken or skewed, the Socket is damaged, you need to replace the new burner
　　 ◆ "Lightly press the burner, put the IC lightly" in use, do not take it with great force, causing damage to the IC or burner
　　◆For BGA package, especially the socket type, the IC is released when it is 1~2mm above the burning socket, let it fall into the burning socket freely, do not directly press the IC into the socket
　　Maintenance matters
　　◆After using the burner every time, the burner should be cleaned to keep the surface of the burner clean and free of dirt
　　 ◆Do not use corrosive cleaning agent, although it can obtain a short-term effect, it will cause serious damage and shorten the service life. Only use electrostatic brushes and precision cleaners to clean the metal shrapnel of the burner (do not use alcohol or lubricant to clean the surface dirt)
　　 ◆The cleaned burner should be stored in a moisture-proof box or a dry safe box
　　 ◆When the burner is not in use for a long time, close the lid, install it in a box, and store it in a sealed, dry and cool place as much as possible to prevent oxidation caused by the storage environment. When using it again, you should first observe whether there is dirt or oxidation (black) on the surface of the burner and clean it with a precision cleaner before use.